We have discussed yesterday about deadboot. And I was able to explained with you what is deadboot all about and the cause. If you want to review what is deadboot just go to this link, What is DEADBOOT?
Ok lets proceed. Our example here is the Samsung S5230W. The status is deadboot. It can't be powered on, it can't put into download mode, can't detect by PC. In short, it's dead. But on the boot area only. It's not totally dead.
So in repairing a deadboot handsets, you must dismantle the unit. Refer to the Riff Box Software, see the pinouts. After dismantling, solder all the pinout. Be carefull not to make a short on the pins. You can see on the image below the picture of the pinouts. Then after you soldered the pinouts, from the software, choose the correct model. The you need a usb cable for the handset. Me, I use my 2 in 1 RJ45 USB cable. Insert the usb cable to PC. Insert also the USB cable to to unit. Then from the software, just press RESURRECT! And after a seconds the software says, "resurrection complete". That's how easy and powerfull the Riff JTAG was.
After resurrecting, assemble the unit and proceed to flashing. You must expect that after the resurrection operation, the unit can now put into download mode for updating it's firmware. So it is needed on firmware updating. How to put into download mode? Please go to this link to know how to put into download mode.
You will now flash the unit using Samsung downloader v5.65. Just see image below.
After flashing, power on the phone. Then, the phone must be ok now :)
Post a Comment
If you have questions, just leave a comments. If it helps you a lot please share my blog to your friends. Thanks.