Hi. Today I will teach you How To Update Cherry Mobile Fusion Bolt To Jelly Bean v4.2.2. If there is a problem with you handset and wasn't be able to fix it via Hard Reset, the final solution is to flash it, or reprogram it. Update or reprogram to higher version is just the same, like this Cherry Mobile Fusion Bolt.
Things needed.
1. Cherry Mobile Fusion Bolt Flasher. Download HERE
2. Cherry Mobile Fusion Bolt Firmware(Jelly Bean 4.2.2). Download HERE
Follow instructions below.
1. Extract both 0417 firmware and the flashing tool.
2. Turn off your Fusion Bolt.
3. Connect one end of the USB Port into computer.
4. Press and hold volume up while you are connecting one end of the USB port to your tablet.
5. Open Device Manager on your PC.
6. You should see the exclamation point on the "Unknown Device".
7. Right click it and click "Update driver"
8. Click Browse.
9. Navigate the folder where you extracted the Flashing tool.
10. Click OK. Wait until the prompt appears and click "Install Driver Software anyway".
11. The installation should be done.
12. Open the folder where you extracted the Flashing Tool.
13. Right click "setup" and select "Run as Administrator".
14. Install the Flashing tool.
15. Open the flashing tool.
16. Click "Replace" and navigate to the folder where you extracted the Ainol Novo 7 Venus firmware.
17. Click the fw file.
18. In recovery image, click image and click "rec".
19. In misc image, click image and click "misc"
20. In system image, click image and select "system".
21. Make sure that Format Data and Format Cache is checked then click Down. Wait for successful message and unplug your tablet.
22. Turn it on and you should see the boot of Ainol.
credits to: Pinoyscreencast
Post a Comment
If you have questions, just leave a comments. If it helps you a lot please share my blog to your friends. Thanks.