Android 8GB mid-2330-S share hang on android logo done by livesuitpack_1.11

Tweet

My customer arrived this morning with her Android Share mid-2330-S 8GB. It stucked on android share logo. Its chipset is A13
I've tried to hard reset it using a free software available but no luck. Why? Do you know why?
It's because the usb debugging of this android was disabled before it turned like this. If the usb debugging was enabled it is fixible by a free software like Android Multi-Tools free software. In a long run, we must reprogram this unit with LiveSuitPack_version_1.11 free software. Of course you will need a 5310 usb cable to connect it with your computer.

For the procedures, just follow the step by step screenshot procedure below.

That's it, the firmware has been loaded.

The unit must be off.
Press Volume Up then insert USB cable. Press power on button shortly for a few times until the drivers will be detected. Then install drivers. The drivers can be seen inside the livesuite software. How? see images below on how to browse the driver.

After installing the drivers, just press YES on the software and you will notice that the software is already running. Just wait to finish it.

Finally press OK and you are done!

I personally check if it works fine. Until i found that the camera was not fine. See error below.

I decided to open the unit and allign the camera. Reassemble again and test the camera. The result was a big success as shown below!

FIRMWARE DOWNLOAD BELOW

CLICK ME TO DOWNLOAD

Share this article :

Tentang Saya
SHORTEDBOARD is from Pangasinan, PH. A Cellphone Technician since 2005. BS ECE graduate. A small time blogger with a simple dreams.
Follow Me : | +Google | Facebook | Twitter